Thermoworks 9009-B INDUSTRIAL DUAL-BLOCK CALIBRATOR Uživatelský manuál stáhnout pdf (Strana 25)

100.0 C

Well temperature in degrees Celsius

Access set-point memory

1 100.

Set-point memory 1, 100°C currently used

To change to another set-point memory press “UP” or “DOWN”.

4 300.

New set-point memory 4, 300°C

Press “SET” to accept the new selection and access the set-point value.

Accept selected set-point memory

7.2.2 Set-point Value

The set-point value may be adjusted after selecting the set-point memory and

pressing “SET”.

4 200.

Set-point 4 value in°C

If the set-point value is correct then press “EXIT” to resume displaying the well

temperature. To change the set-point values, press “SET” and then press “UP”

or “DOWN” to adjust the set-point value.

220.00

New set-point value

When the desired set-point value is reached press “SET” to accept the new

value and access the temperature scale units selection. If “EXIT” is pressed in

stead then any changes made to the set-point will be ignored.

Accept new set-point value

7.2.3 Temperature Scale Units

The temperature scale units of the controller maybe set by the user to degrees

Celsius (°C) or Fahrenheit (°F). The units are used in displaying the well tem

perature, set-point, and proportional band.

Press “SET” after adjusting the set-point value to change display units.

Un= C Scale units currently selected

Press “UP” or “DOWN” to change the units.

7 Controller Operation

Temperature Set-point

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 44 45

Žádné komentáře

Thermoworks 9009-B INDUSTRIAL DUAL-BLOCK CALIBRATOR Uživatelský manuál Strana 25